Skip to main content

NOTICE: Due to a lapse in annual appropriations, most of this website is not being updated. Learn more.

Form submissions will still be accepted but will not receive responses at this time. Sections of this site for programs using non-appropriated funds (such as NVLAP) or those that are excepted from the shutdown (such as CHIPS and NVD) will continue to be updated.

U.S. flag

An official website of the United States government

Official websites use .gov
A .gov website belongs to an official government organization in the United States.

Secure .gov websites use HTTPS
A lock ( ) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.

Evidence for a geometry-dependent bandgap energy and heat accumulation in low-dimensional optical cavities

Published

Author(s)

Babak Nikoobakht

Abstract

Within an optical nanocavity, the temperature dependence of the emission wavelength defines its emission energy stability. Thermal management, therefore, is crucial in controlling wavelength drift and/or radiative recombination rates, especially in electrically driven light sources. Our results show that heat accumulation in a nanocavity directly depends on its geometry, orientation, and interface area with the underlying substrate. We use the temperature dependence of the bandgap to compare the heat retention in nanocavities with lateral and standing orientations. For this purpose, we compare lateral nanofins (fins) and free-standing nanopillars, a.k.a., nanowires (NWs). Hyperspectral cathodoluminescence (CL) microscopy is used to monitor the temperature dependence of the bandgap. Results show that the emission energy of a lateral nanocavity is less dependent on temperature variation compared with that of a standing one. This variation in temperature dependence is attributed to the extent of heat accumulation in the lattice. It is shown that the retained heat in a nanocavity depends on its interface area with the underlying substrate and its surface-to-volume ratio, where the former is the predominant factor. Theoretical modeling shows that introducing a short heat pulse to a standing-nanostructure results in a rapid temperature increase. The initial heating is due to the ultrafast phonon–phonon couplings and build-up of lattice heat. By increasing the interface area between the nanostructure and the substrate, the temperature spike disappeared. Results show the interface area has a far more important contribution than a larger surface-to-volume ratio in heat dissipation. These findings are particularly significant in thermal management of electrically driven optical nanocavities, where operating temperatures could exceed 350 K. As such, although the design and fabrication of efficient nanocavities are essential, controlling their thermal interactions with the surrounding is equally important. Interfacial engineering thus plays a vital role in developing built-in mechanisms for realization of efficient and stable nanoscale light sources.
Citation
Nanophotonics
Volume
15
Issue
4

Keywords

AlGaN, fin, light-emitting diode, nanoLED, optical cavity, cathodoluminescence

Citation

Nikoobakht, B. (2025), Evidence for a geometry-dependent bandgap energy and heat accumulation in low-dimensional optical cavities, Nanophotonics, [online], https://doi.org/10.1117/1.JNP.19.042204, https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=959223 (Accessed October 2, 2025)

Issues

If you have any questions about this publication or are having problems accessing it, please contact [email protected].

Created June 18, 2025, Updated September 30, 2025
Was this page helpful?