Skip to main content
U.S. flag

An official website of the United States government

Official websites use .gov
A .gov website belongs to an official government organization in the United States.

Secure .gov websites use HTTPS
A lock ( ) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.

Effect of Diamond Nanolubricant on R134a Pool Boiling Heat Transfer with Extensive Measurement and Analysis Details

Published

Author(s)

Mark A. Kedzierski

Abstract

This paper quantifies the influence of diamond nanoparticles on the boiling performance of R134a/polyolester mixtures on a roughened, horizontal, flat surface. Nanofluids are liquids that contain dispersed nano-size particles. A lubricant based nanofluid (nanolubricant) was made with a synthetic ester and 10 nm diameter diamond particles suspended in the mixture to roughly a 2.6 % volume fraction. For the 0.5 % nanolubricant mass fraction, the nanoparticles caused a heat transfer enhancement relative to the heat transfer of pure R134a/polyolester (99.5/0.5) as large as 129 % for the best performing tests. A similar enhancement was observed for the R134a/nanolubricant (99/1) mixture, which had a heat flux that was on average 91 % larger than that of the R134a/polyolester (99/1) mixture. Further increase in the nanolubricant mass fraction to 2 % resulted in boiling heat transfer degradation of approximately 19 % for the best performing tests. Due to the poor quality of the nanolubricant suspension, the performance of the (99.5/0.5) and the (98/2) nanolubricant mixtures decayed over time to, on average, 36 % and 76 % of the of pure R134a/polyolester performance, respectively. Thermal conductivity and viscosity measurements and a refrigerant\lubricant mixture pool-boiling model were used to suggest that increases in thermal conductivity and lubricant viscosity are mainly responsible for the heat transfer enhancement due to nanoparticles. Particle size measurements were used to suggest that particle agglomeration induced a lack of performance repeatability for the (99.5/0.5) and the (98/2) mixtures. From the results of the present study, it is speculated that if a good dispersion of nanoparticles in the lubricant is not obtained, then the agglomerated nanoparticles will not provide interaction with bubbles, which is favorable for heat transfer. Further research with nanolubricants and refrigerants are required to establish a fundamental understanding of the mechanisms that control nanofluid heat transfer.
Citation
Technical Note (NIST TN) - 1631
Report Number
1631

Keywords

additives, boiling, diamond, enhanced heat transfer, nanotechnology, refrigerants, refrigerant/lubricant mixtures

Citation

Kedzierski, M. (2009), Effect of Diamond Nanolubricant on R134a Pool Boiling Heat Transfer with Extensive Measurement and Analysis Details, Technical Note (NIST TN), National Institute of Standards and Technology, Gaithersburg, MD, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=902401 (Accessed March 29, 2024)
Created August 6, 2009, Updated February 19, 2017