Ling, A.
and Wilkin, N.
(1999),
Fast Probing Considerations for On-Machine Inspection of Parts, NIST Interagency/Internal Report (NISTIR), National Institute of Standards and Technology, Gaithersburg, MD (Accessed May 4, 2026)
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
Secure .gov websites use HTTPS
A lock (
) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.
Fast Probing Considerations for On-Machine Inspection of Parts
Published
Author(s)
,
Abstract
A calibration procedure for on-machine probing is developed. This is necessary if the machine is used as a coordinate measuring machine to measure the absolute part dimensions. This is most crucial in turning machines where the turret is unable to go below the centerline of the part. However, in measurements on turning centers and machining centers where a differential measurement can be achieved on a feature, calibration is not as crucial. On-machine-probing variables, such as the feed rate at which probing occurs, have a proportional relationship to effective errors in the timing of the probe triggering system. Experiments were performed to verify and model machine feed rate during probing with resulting systematic measurement error.Citation
NIST Interagency/Internal Report (NISTIR) - 6415
Report Number
6415
NIST Pub Series
Pub Type
NIST Pubs
Keywords
fast probing, on-machine probing, part inspection, probe tip calibration
Citation
Issues
If you have any questions about this publication or are having problems accessing it, please contact [email protected].
Created October 1, 1999, Updated February 19, 2017