Effects of wafer noise on the detection of 20 nm defects using optical volumetric inspection

Published

February 11, 2015

Author(s)

Bryan M. Barnes, Francois R. Goasmat, Martin Y. Sohn, Hui Zhou, Andras Vladar, Richard M. Silver

Abstract

Patterning imperfections in semiconductor device fabrication may either be noncritical [e.g., line edge roughness (LER)] or critical, such as defects that impact manufacturing yield. As the sizes of the pitches and linewidths decrease in lithography, detection of the optical scattering from killer defects may be obscured by the scattering from other variations, called wafer noise. Understanding and separating these optical signals are critical to reduce false positives and overlooked defects. The effects of wafer noise on defect detection are assessed using volumetric processing on both measurements and simulations with the SEMATECH 9-nm gate intentional defect array. Increases in LER in simulation lead to decreases in signal-to-noise ratios due to wafer noise. Measurement procedures illustrate the potential uses in manufacturing while illustrating challenges to be overcome for full implementation. Highly geometry-dependent, the ratio of wafer noise to defect signal should continue to be evaluated for new process architectures and production nodes.

Citation

Journal of Micro/Nanolithography, MEMS, and MOEMS

Volume

14

Issue

1

Pub Type

Journals

Download Paper

DOI Link

Keywords

wafer noise, defect inspection, volumetric processing, defect metrology, three-dimensional image processing

Citation

Barnes, B. , Goasmat, F. , Sohn, M. , Zhou, H. , Vladar, A. and Silver, R. (2015), Effects of wafer noise on the detection of 20 nm defects using optical volumetric inspection, Journal of Micro/Nanolithography, MEMS, and MOEMS, [online], https://doi.org/10.1117/1.JMM.14.1.014001 (Accessed October 10, 2025)