UV EFFECTS IN TOOTH ENAMEL AND THEIR POSSIBLE APPLICATION IN EPR DOSIMETRY WITH FRONT TEETH

Published

January 4, 2010

Author(s)

S Sholom, Marc F. Desrosiers, V Chumak, N. Luckyannov, S.L. Simon, A Bouville

Abstract

Quality control dosimetry is important to the routine operation of a radiation processing facility. For many applications this dosimetry must be traceable to a national primary standard. After irradiation at an industrial facility, NIST-supplied transfer dosimeters are certified by measurement and dose interpolation from the NIST calibration curve. However, prior to computing the absorbed dose the dosimeter response must be adjusted for the temperature difference between irradiation temperature for the alanine system calibration and the irradiation temperature for the industrial process. For most industrial applications, the temperature is not controlled and varies during the irradiation process. The alanine dosimeter response has a dependence on irradiation temperature, which is compensated for by applying a correction factor to the dosimeter response to compute the absorbed dose. Moreover, there is no consensus protocol to estimate the irradiation temperature and apply this correction. This work approximates industrial temperature profiles using a temperature controlled 60Co source, then compares the relative effectiveness of commonly-used industrial methods to correct for irradiation temperature influence on the alanine dosimeter response.

Citation

Health Physics

Volume

98

Pub Type

Journals

Keywords

dosimetry, electron paramagnetic resonance, gamma ray, ionizing radiation, tooth enamel, ultraviolet light

Citation

Sholom, S. , Desrosiers, M. , Chumak, V. , Luckyannov, N. , Simon, S. and Bouville, A. (2010), UV EFFECTS IN TOOTH ENAMEL AND THEIR POSSIBLE APPLICATION IN EPR DOSIMETRY WITH FRONT TEETH, Health Physics (Accessed October 20, 2025)