NOTICE: Due to a lapse in annual appropriations, most of this website is not being updated. Learn more.
Form submissions will still be accepted but will not receive responses at this time. Sections of this site for programs using non-appropriated funds (such as NVLAP) or those that are excepted from the shutdown (such as CHIPS and NVD) will continue to be updated.
An official website of the United States government
Here’s how you know
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
Secure .gov websites use HTTPS
A lock (
) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.
Contributions of sub-surface intergranular phases on fatigue crack initiation in additively manufactured austenitic stainless steel
Published
Author(s)
Ian Wietecha-Reiman, Andrew Iams, S. Sabol, T. Palmer
Abstract
Fatigue failures in additively manufactured 316L austenitic stainless steel produced using laser powder bed fusion processes are often attributed to the presence of process-related defects or surface roughness. To better investigate the role of surface roughness on fatigue properties, internal pores were mitigated using hot isostatic pressing, and strain-controlled fatigue testing was performed with the surface in the as-deposited condition. In the absence of internal defects, crack initiation was expected to occur at the surface, which displayed arithmetic mean surface roughness (Sa) values between 10 and 40 µm as the build angle decreased from a vertical (90°) to a 45° orientation. Even though a decrease in average fatigue life with this increase in surface roughness was observed, there was no evidence of fatal cracks initiating from as-deposited surface asperities. Instead, widespread brittle intergranular fracture occurred within fine-grained sub-surface regions in the contour passes along the specimen perimeter that were populated by sub-micrometer-sized Cr2N particles and nanometer-sized α-tridymite oxides that decorated the austenite grain boundaries. The width of these brittle fracture regions increased by 100 µm as the build angle changed from 90° to 45°. At the same time, the fraction of decorated grain boundaries (30–45%) and precipitate length (up to 10 µm) within these wider contour regions increased, driving the observed decreases in the fatigue life.
Wietecha-Reiman, I.
, Iams, A.
, Sabol, S.
and Palmer, T.
(2025),
Contributions of sub-surface intergranular phases on fatigue crack initiation in additively manufactured austenitic stainless steel, Journal of Materials Science, [online], https://doi.org/10.1007/s10853-025-11259-w, https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=957516
(Accessed October 16, 2025)