Estimating the Receiver Delay for Ionosphere-Free Code (P3) GPS Time Transfer

Published

December 5, 2006

Author(s)

Victor S. Zhang

Abstract

The ionosphere-free code (P3) GPS time transfer uses the dual-frequency measurements from GPS geodetic receivers to minimize the errors in the ionospheric delay correction. The P3 GPS time transfer requires the knowledge of the receiver delays on both the L1 and L2 frequencies (P3 receiver delay). Very few receivers used for P3 GPS time transfer are absolute calibrated due to the complexity of the calibration. The BIPM has started regular calibration campaigns to determine the delay of the P3 receivers around the world against an absolute calibrated BIPM receiver. This paper presents a method of estimate the P3 receiver delay using a calibrated conventional GPS common-view receiver. The uncertainty of the estimated P3 receiver delay is about the same as that obtained by the differential calibration between two P3 receivers. Each timing laboratory with a calibrated common-view receiver can apply this method to estimate the delay of an on-site P3 receiver. This method can also be used to simplify the differential calibration of both the common-view receiver and the P3 receiver with one travel common-view receiver.

Proceedings Title

Proc. 2006 PTTI Mtg.

Conference Dates

December 5-8, 2006

Conference Location

Reston, VA

Pub Type

Conferences

Download Paper

Local Download

Keywords

frequency transfer, GPS time

Citation

Zhang, V. (2006), Estimating the Receiver Delay for Ionosphere-Free Code (P3) GPS Time Transfer, Proc. 2006 PTTI Mtg., Reston, VA, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=50472 (Accessed May 8, 2026)

Additional citation formats