Low, S.
and Fink, J.
(2003),
Effects of Bending in Brass Rockwell B Scale Test Blocks, IMEKO TC
(Accessed June 24, 2025)
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
Secure .gov websites use HTTPS
A lock (
) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.
Effects of Bending in Brass Rockwell B Scale Test Blocks
Published
Author(s)
,
Abstract
As part of a project to produce primary hardness reference blocks for the Rockwell B hardness scale at the National Institute of Standards and Technology (NIST), studies were conducted to observe the stability of the hardness value of the blocks over a period of time and with use. A study of brass test blocks at the 42 HRBW level revealed some interesting instability results when tested using the NIST standardizing machine with it's large diameter sample support. After a relatively small number of indentations, each block exhibited an abrupt change in the apparent hardness of the test block. Examination of this phenomena revealed that the abrupt change in hardness was the result of a combination of the bending of the block and the use of the NIST machine's large diameter flat anvil. This paper discusses the reasons that block bending affects the hardness measurement.Citation
IMEKO TC
Pub Type
Journals
Keywords
bending, Rockwell hardness, test block
Citation
Issues
If you have any questions about this publication or are having problems accessing it, please contact [email protected].
Created June 2, 2003, Updated February 17, 2017