Skip to main content

NOTICE: Due to a lapse in annual appropriations, most of this website is not being updated. Learn more.

Form submissions will still be accepted but will not receive responses at this time. Sections of this site for programs using non-appropriated funds (such as NVLAP) or those that are excepted from the shutdown (such as CHIPS and NVD) will continue to be updated.

U.S. flag

An official website of the United States government

Official websites use .gov
A .gov website belongs to an official government organization in the United States.

Secure .gov websites use HTTPS
A lock ( ) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.

Electrodeposition of Copper and Copper-Aluminum Alloys From a Room-Temperature Chloroaluminate Molten Salt

Published

Author(s)

B J. Tierney, W R. Pitner, J A. Mitchell, C L. Hussey, Gery R. Stafford

Abstract

The electrodeposition of copper and copper-aluminum alloys was investigated in the Lewis acidic aluminum chloride-1-methyl-3-ethylimidazolium chloride [60.0-40.0 mole percent (m/o)] molten salt containing electrogenerated Cu(I) at 40 + 1 degree Celsius}. Sampled current and rotating ring-disk electrode voltammetry experiments indicated that it was possible to produce Cu-Al alloy deposits at potentials positive of that corresponding to the electrodeposition of bulk aluminum (O V). For a 5.0 x 10-2 mol L-1 solution of Cu(I), the onset of the aluminum codeposition process was found to occur at around 0.30 V versus the Al(III)/ Al couple; however, a limiting current for the reduction of Cu(I) to pure copper metal can be observed in the 0.60 to 0.30 V potential interval in this solution. The Cu-al alloy composition was found to be independent of the Cu(I) concentration, reaching a maximum value of 43 atomic percent (a/o) aluminum at O V. The surface morphology of bulk Cu-Al alloy electrodeposits was highly dependent on the aluminum content; pure copper deposits had a dense, nodular appearance, whereas deposits containing appreciable amounts of aluminum consisted of fragile dendrites. X-ray diffraction studies indicated that Cu-Al deposits containing about 7.2 a/o Al retained the fcc copper structure; however, deposits containing 12.8 a/o Al were two-phase with the second phase tentatively identified as martensitic Β'-Cu3Al. This phase appears to form before fcc copper becomes saturated with aluminum.
Citation
Journal of the Electrochemical Society
Volume
145

Keywords

copper, copper-aluminum alloys, electrodeposition

Citation

Tierney, B. , Pitner, W. , Mitchell, J. , Hussey, C. and Stafford, G. (1998), Electrodeposition of Copper and Copper-Aluminum Alloys From a Room-Temperature Chloroaluminate Molten Salt, Journal of the Electrochemical Society, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=852878 (Accessed October 14, 2025)

Issues

If you have any questions about this publication or are having problems accessing it, please contact [email protected].

Created August 31, 1998, Updated October 12, 2021
Was this page helpful?