Prototype Cantilevers for SI Traceable NanoNewton Force Calibration

Published

September 20, 2006

Author(s)

Richard S. Gates, Jon R. Pratt

Abstract

A series of extremely uniform prototype reference cantilevers has been created that can be used to calibrate the spring constants of atomic force microscope (AFM) cantilevers and other micromechanical structures. By utilizing optimal combinations of material, design and the latest microfabircation processing trechniques, arrays of cantilevers were created from single crystal (100) silicon. Nominal spring constants were estimated to be in the range 0.02 N/m to 0.2 N/m. Resonance frequency measurements were used to assess the uniformity of devices from different portions of a silicon-on-insulator wafer and ind ifferent processing batches. Variations of less than 1% (relative standard deviation) in resonance frequency attested to the high degree of uniformity achieved. Independent calibration of cantilevers in the array using an electrostatic force balance indicated the actual spring constants ranged from 0.0258 N/m 0.0005 N/m (1.9%) to 0.2057 N/m 0.0009 N/m (0.44%). The results confirm the feasibility of creating uniform reference cantilevers and calibrating them using an SI- traceable technique, making these devices excellent candidates as force calibration standard reference materials for AFM.

Citation

Measurement Science & Technology

Volume

17

Pub Type

Journals

Download Paper

Local Download

Keywords

AFM, calibration, cantilever, spring constant

Citation

Gates, R. and Pratt, J. (2006), Prototype Cantilevers for SI Traceable NanoNewton Force Calibration, Measurement Science & Technology, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=822599 (Accessed October 10, 2025)