NIST logo

Publications Portal

You searched on: Author: adam creuziger Sorted by: date

Displaying records 1 to 10 of 11 records.
Resort by: Date / Title

1. Uncertainty in Retained Austenite Measurements Applied to Individual Crystallographic Orientations
Published: 5/6/2015
Authors: Adam A Creuziger, Thomas H Gnaupel-Herold
Abstract: A technique to measure the phase volume fraction of an individual orientation and the uncertainty in the measurement is demonstrated in this paper. The technique of complete pole figure averaging was used to assess the phase fraction of retained aust ...

2. Crystallographic Texture Evolution in 1008 Steel Sheet During Multi-Axial Tensile Strain Paths
Published: 1/7/2014
Authors: Adam A Creuziger, Lin Hu, Thomas H Gnaupel-Herold, Anthony D. Rollett
Abstract: This paper considers the crystallographic texture evolution in a 1008 low carbon steel. The texture evolution along uniaxial, plane strain and balanced biaxial strain states were measured. For uniaxial testing, grains tend to rotate such that the {11 ...

3. Advanced Biaxial Cruciform Testing at the NIST Center for Automotive Lightweighting
Published: 1/1/2014
Authors: Mark A Iadicola, Adam A Creuziger, Timothy J Foecke
Abstract: Modeling of sheet metal forming operations requires mechanical properties data at very large tensile strains and various biaxial strain paths. Typically these data are developed along strain ratio paths that are linear and monotonic, but actual fo ...

4. Measurement of Uncertainty in Orientation Distribution Function (ODF) Calculations
Published: 10/28/2013
Authors: Adam A Creuziger, Komal Syed, Thomas H Gnaupel-Herold

5. A Model for Calculating Diffraction Elastic Constants
Published: 1/18/2012
Authors: Thomas H Gnaupel-Herold, Adam A Creuziger, Mark A Iadicola
Abstract: An alternate model is proposed to calculate the diffraction elastic constants from the elastic constants of the single crystal. It is based on the inverse elastic susceptibility and thus it is related to the elastic polarization approach widely known ...

6. Evolution of Anisotropic Stress Factors with Texture in the Biaxial Deformation of HSLA50 Steel
Published: 1/3/2012
Authors: Thomas H Gnaupel-Herold, Adam A Creuziger, Mark A Iadicola
Abstract: The effects of crystallographic texture produced by biaxial deformation on the diffraction elastic constants (DEC) are discussed. Predictions of DEC values from established and new models of grain interactions are compared with experimental data. T ...

7. Texture Evolution in TRIP 590 Steels
Published: 1/3/2012
Authors: Adam A Creuziger, Lin Hu, Thomas H Gnaupel-Herold, A. D. Rollett

8. Report on VAMAS Round Robin of ISO 13067: Microbeam Analysis,Electron Backscatter Diffraction,Measurement of Average Grain Size
Series: NIST Interagency/Internal Report (NISTIR)
Report Number: 7814
Published: 9/14/2011
Authors: Adam A Creuziger, Mark D Vaudin
Abstract: The authors recently participated in a round robin evaluation of a new ISO document draft, ISO 13067: Microbeam analysis ‹ Electron backscatter diffraction ‹ Measurement of average grain size. This report details the results of the study, some of th ...

9. Diffraction study of the retained austenite content in TRIP steels
Published: 1/19/2011
Authors: Thomas H Gnaupel-Herold, Adam A Creuziger
Abstract: The results of a study of using neutron diffraction for determining the retained austenite content of TRIP steels are presented. The study covers a wide area of materials, deformation modes (uniaxial, biaxial and plane strain), strains, and the retai ...

10. Tranformation Potential Predictions for the Stress Induced Austenite to Martensite Transformation in Steel
Published: 9/28/2009
Authors: Adam A Creuziger, Timothy J Foecke
Abstract: The stress induced transformation behavior of retained austenite is considered in this work. With the development of transformation induced plasticity (TRIP) steels this deformation mode is of growing importance. Twinned martensite structures were ca ...

Search NIST-wide:

(Search abstract and keywords)

Last Name:
First Name:

Special Publications:

Looking for a NIST Special Publication (NIST SP Series)? Place the series number and dash in the report number field (Example: 800-) and begin your search.

  • SP 250-XX: Calibration Services
  • SP 260-XX: Standard Reference Materials
  • SP 300-XX: Precision Measurement and Calibration
  • SP 400-XX: Semiconductor Measurement Technology
  • SP 480-XX: Law Enforcement Technology
  • SP 500-XX: Computer Systems Technology
  • SP 700-XX: Industrial Measurement Series
  • SP 800-XX: Computer Security Series
  • SP 823-XX: Integrated Services Digital Network Series