Take a sneak peek at the new NIST.gov and let us know what you think!
(Please note: some content may not be complete on the beta site.).

View the beta site
NIST logo

Bookmark and Share

Time and Frequency from A to Z: To to Tw

A-Al Am-B C-Ce Ch-Cy D-Do Dr-E F G H I J-K L M
N-O P Q-Ra Re-Ru S-So St-Sy T-Te Ti To-Tw U-W X-Z Notes Index

Total Deviation

A statistic used to estimate oscillator stability. Total deviation reduces the estimation errors of the Allan deviation at long averaging times, and thus is well suited for estimating long-term stability.


The property of a result of a measurement or the value of a standard whereby it can be related to stated references, usually national or international standards, through an unbroken chain of comparisons all having stated uncertainties.

For general information about traceability, visit the NIST Traceability web site. For information specific to time and frequency metrology, visit the NIST Frequency Measurement Service page.

Tuning Fork

A metal two-pronged fork that, when struck, produces an almost pure tone of a predetermined frequency. Tuning forks are used for simple frequency calibrations, such as tuning musical instruments, and calibrating radar guns used by law enforcement agencies.

Two Way Time and Frequency Transfer

A measurement technique used to compare two clocks or oscillators at remote locations. The two-way method involves signals that travel both ways between the two clocks or oscillators that are being compared, as shown in the graphic below.


A half-duplex channel is a one-way system that is “turned around” to retransmit a signal in the opposite direction. In this method, the one-way delay between the transmitter and receiver is estimated as one-half of the measured round trip delay. The delay estimate can be sent to the user and applied as a correction, or the transmitter can advance the signal so that it arrives at the user's site on time. The latter is how the NIST Automated Computer Time Service (ACTS) system works. Internet time transfers using the Network Time Protocol (NTP) also use a half-duplex technique.

A full-duplex system uses one-way signals transmitted simultaneously in both directions, often through a communications satellite. In this case data must be exchanged in both directions so that the two data sets can be differenced. For more information, visit the NIST Two Way Transfer page.

A-Al Am-B C-Ce Ch-Cy D-Do Dr-E F G H I J-K L M
N-O P Q-Ra Re-Ru S-So St-Sy T-Te Ti To-Tw U-W X-Z Notes Index