Skip to main content
U.S. flag

An official website of the United States government

Official websites use .gov
A .gov website belongs to an official government organization in the United States.

Secure .gov websites use HTTPS
A lock ( ) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.

Design and test of reliable, high strength, ingressive polycrystalline silicon microgripper arrays

Published

Author(s)

Siddharth Hazra, Jack L. Beuth, Grant A. Myers, Frank W. DelRio, Maarten de Boer

Abstract

We present the design and extensive validation of a micromachined gripper array that enables reliable transmission of forces up to 10 milliNewtons. The gripper is constructed with polycrystalline silicon, a brittle material. Two ingressive snap-and-lock designs are presented. After developing design guidelines, it is shown that the first array is functional and yields strength data in good agreement with published literature. However, a risk remains that the gripper array rather than the tensile bar fails. Therefore, an improved geometry is designed and it is shown using statistical strength testing that it is robust with respect to failure. Scanning confocal Raman imaging directly confirms that the local peak tensile stresses in the robust gripper array are approximately 40 % of the lower bound material strength, and also resolves a small stress variation across the array.
Citation
Journal of Micromechanics and Microengineering
Volume
25

Keywords

microgripper array, snap-fit latch, MEMS reliability, confocal Raman imaging

Citation

Hazra, S. , Beuth, J. , Myers, G. , DelRio, F. and de Boer, M. (2015), Design and test of reliable, high strength, ingressive polycrystalline silicon microgripper arrays, Journal of Micromechanics and Microengineering, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=916443 (Accessed March 19, 2024)
Created January 1, 2015, Updated October 12, 2021