Take a sneak peek at the new NIST.gov and let us know what you think!
(Please note: some content may not be complete on the beta site.).

View the beta site
NIST logo

Publication Citation: SEM imaging of ultra-high aspect ratio hole features

NIST Authors in Bold

Author(s): John S. Villarrubia; Aron Cepler; Benjamin D. Bunday; Bradley Thiel;
Title: SEM imaging of ultra-high aspect ratio hole features
Published: March 29, 2012
Abstract: In-line, non-destructive process control metrology of high aspect ratio (HAR) holes and trenches has long been a known gap in metrology. Imaging the bottoms of at-node size beyond 10:1 AR contact holes in oxide has not yet been demonstrated. Nevertheless, holes and trenches of 30:1, 40:1, or even 60:1 will soon enter production, with these etches being applied to various homogeneous and multi-layer stacks of Si and SiO2. The need comes from Moore‰s Law and increasing functional density on microchips, for which true 3D memory devices will soon be manufactured. These can take many different forms, but a common building block will be these ultra-HAR etched features. In this work, we show experimental and simulated results from the NIST JMONSEL program to assess the feasibility of measuring such features using both conventional low voltage scanning electron microscopy (SEM) and higher beam energies and low vacuum conditions to ameliorate charging. In our measurements, higher voltage SEM did not improve upon conventional critical dimension (CD)-SEM. Simulations suggest the reason is a failure to overcome a negative surface potential. Although a signal can be detected from the bottom of contact holes in typical imaging conditions, in the CD-SEM, it is likely that it will be very small and possibly below the noise floor.
Proceedings: Metrology, Inspection, and Process Control for Microlithography XXVI, Proceedings of SPIE Volume: 8324
Volume: 8324
Pages: pp. 83241N-1 - 83241N-14
Location: San Jose, CA
Dates: February 12-16, 2012
Keywords: CD-Metrology, 3D Memory, CD-SEM, contact holes, HAR features
Research Areas: Critical Dimension and Overlay Metrology, Electron microscopy (EM, TEM, SEM, STEM), Metrology and Standards for Manufacturing Processes
DOI: http://dx.doi.org/10.1117/12.916552  (Note: May link to a non-U.S. Government webpage)
PDF version: PDF Document Click here to retrieve PDF version of paper (2MB)