Skip to main content
U.S. flag

An official website of the United States government

Official websites use .gov
A .gov website belongs to an official government organization in the United States.

Secure .gov websites use HTTPS
A lock ( ) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.

The Recovery of Elastic Properties at 35 C in Trip 700 Steel Following Deformation

Published

Author(s)

David J. Pitchure, Richard E. Ricker

Abstract

The influence of plastic deformation on the elastic properties that determine the magnitude of springback following forming was investigated using dynamic modulus analysis. For this study, the elastic modulus of TRIP 700 steel was measured continuously at 35 C and a loading frequency of 1.0 Hz for 1,000 minutes following deformation by cold rolling to varying levels up to 27 %. The elastic modulus increased at an exponentially decaying rate during these experiments and with a magnitude that increased with pre-strain. These observations are consistent with the hypothesis that deformation creates microstructural defects that contribute compliance when the stress state changes and that these defects are removed by annealing at this low temperature.
Citation
Journal of Materials Engineering and Performance
Volume
16
Issue
3

Keywords

anelastic, dynamic modulus analysis, elastic modulus, forming, modulus recovery, springback, TRIP steel

Citation

Pitchure, D. and Ricker, R. (2007), The Recovery of Elastic Properties at 35 C in Trip 700 Steel Following Deformation, Journal of Materials Engineering and Performance, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=853488 (Accessed March 28, 2024)
Created June 1, 2007, Updated February 19, 2017