Skip to main content
U.S. flag

An official website of the United States government

Official websites use .gov
A .gov website belongs to an official government organization in the United States.

Secure .gov websites use HTTPS
A lock ( ) or https:// means you’ve safely connected to the .gov website. Share sensitive information only on official, secure websites.

Development of a Bolometer Detector System for the NIST High Accuracy Infrared Spectrophotometer

Published

Author(s)

Yuqin Zong, Raju V. Datla

Abstract

A bolometer detector system is developed for the high accuracy infrared spectropho-meter at the National Institute of Standards and Technology (NIST) to provide maximum sensitive, spatial uniformity and linearity of response covering the entire infrared spectral range. Th3e spatial response variation was measured to be within + or -0.1%. The linearity of the detector output was measured over three decades of input power. After applying a simple correction procedure, the detector output was found to deviate less than 0.2% from linear behavior over this range. The noise equivalent power (NEP) of the bolometer system was 6x10-12 W/Ohz at the frequency of 80 Hz. The detector output 3dB roll off frequency was 200 Hz. The detector output was stable to within + or -0.05% over a 15 minute period. These results demonstrate that the bolometer detector system will serve as an excellent detector for the high accuracy infrared spectrophotometer.
Citation
Journal of Research (NIST JRES) -
Volume
103
Issue
6

Keywords

cryogenic bolometer, infrared detector, linearity, noise, spatial response, spectrophotometer

Citation

Zong, Y. and Datla, R. (1998), Development of a Bolometer Detector System for the NIST High Accuracy Infrared Spectrophotometer, Journal of Research (NIST JRES), National Institute of Standards and Technology, Gaithersburg, MD, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=841282 (Accessed March 28, 2024)
Created November 1, 1998, Updated February 19, 2017