Influence of Heating Rate on Flow Stress in High-Speed Machining Processes

Published

April 1, 2004

Author(s)

Timothy J. Burns, Robert W. Ivester, Michael Kennedy, Richard L. Rhorer, Matthew A. Davies, Howard Yoon, Lyle E. Levine, Richard J. Fields, D Basak, Eric P. Whitenton

Abstract

For several decades, a major focus of machining research has been the measurement and prediction of temperature. Here, the influence of the rate of heating on the flow stress, and the implications of this for finite-element modeling of high speed metal-cutting processes, will be discussed. First, for a range of chip thicknesses, a description will be given of some infrared microscopic measurements, performed at NIST, of the temperature field at the tool-chip interface during steady-state orthogonal machining of AISI 1045 steel. Next, some unsuccessful attempts to predict these thermal fields using commercial finite-element software will be discussed. Following this, results will be presented of some recent NIST research using a split-Hopkinson (Kolsky) bar with a rapid preheating capability. This work implies that, in AISI 1045 steel and related mild steels of interest in manufacturing, the thermal-softening effect during high-speed machining is significantly smaller than predicted by current constitutive response models. Finally, it will be shown that improved finite-element predictions of the maximum temperature on the tool-chip interface are obtained using the pulse-heated Kolsky bar data.

Conference Dates

May 4-5, 2004

Conference Location

Cluny, 1, FR

Conference Title

7th CIRP International Workshop on Modeling and Machining Operations

Pub Type

Conferences

Keywords

material behavior, metal cutting, SHPB strain, strain rate, temperature

Citation

Burns, T. , Ivester, R. , Kennedy, M. , Rhorer, R. , Davies, M. , Yoon, H. , Levine, L. , Fields, R. , Basak, D. and Whitenton, E. (2004), Influence of Heating Rate on Flow Stress in High-Speed Machining Processes, 7th CIRP International Workshop on Modeling and Machining Operations, Cluny, 1, FR (Accessed April 19, 2024)