Take a sneak peek at the new NIST.gov and let us know what you think!
(Please note: some content may not be complete on the beta site.).

View the beta site
NIST logo

Publication Citation: Model for Transient Behavior of Pulse Tube Cryocooler

NIST Authors in Bold

Author(s): Gershon Grossman; Peter E. Bradley; Michael A. Lewis; Ray Radebaugh;
Title: Model for Transient Behavior of Pulse Tube Cryocooler
Published: January 01, 2011
Abstract: This article describes an investigation of the transient behavior of a small (2.0 W at 85 K) Pulse Tube cryocooler operating at 120 Hz with an average pressure of 3.5 MPa, capable of relatively fast cool-down to about 60 K. In a series of experiments, the cold-end temperature was measured as a function of time in a complete cool-down and subsequent warm-up cycle, with no load and different quantities of excess mass at the cold end. A transient heat transfer model was developed, which considers the effects of the cooling power extracted at the cold end and that of the heat gain at the warm end on the cool-down time. The heat gain factor was calculated from warm-up data, and found approximately the same for all experiments. Using the same model with cool-down data enables to determine both the gross and net cooling power as functions of time, but more importantly - as functions of the cold end temperature. An expression was derived for the cold-end temperature as a function of time for any amount of excess mass, including zero. The cool down time of the ,leanŠ cryocooler (with no excess mass) was found to be less than 50 seconds. This cool-down/warm-up method for evaluating the cooling power of a cryocooler seems simpler than steady-state experiments with a heater simulating load at the cold end. Using the heat transfer model with data from one or two good experiments conducted in the above manner, can yield both the gross and net cooling powers of a cryocooler as functions of the cold end temperature, and allow to determine cool-down time with any amount of excess thermal mass. While the net cooling power during cool-down differs somewhat from that under steady state operation, the former can serve as a good measure for the latter.
Citation: Cryogenics
Volume: 51
Pages: pp. 124 - 131
Keywords: Cool-Down, Pulse Tube, Transient, Warm-Up
Research Areas: Thermophysics, Cryogenics
PDF version: PDF Document Click here to retrieve PDF version of paper (859KB)