Take a sneak peek at the new NIST.gov and let us know what you think!
(Please note: some content may not be complete on the beta site.).

View the beta site
NIST logo

Publication Citation: Finite-element analysis and experimental investigation of probe shape effect on initial plastic yield

NIST Authors in Bold

Author(s): Li Ma; Dylan Morris; Stefhanni Jennerjohn; David Bahr; Lyle E. Levine;
Title: Finite-element analysis and experimental investigation of probe shape effect on initial plastic yield
Published: March 03, 2009
Abstract: Sudden displacement excursions during load-controlled nanoindentation of relatively dislocation-free surfaces of metals are frequently associated with dislocation nucleation, multiplication, and propagation. Insight into the nanomechanical origins of plasticity in metallic crystals may be gained through estimation of the stresses that nucleate dislocations. An assessment of the potential errors in the experimental measurement of nucleation stresses, especially in materials that exhibit the elastic-plastic transition at very small indentation depths, is critical. In this work, the near-apex shape of a Berkovich probe was measured by scanning probe microscopy. Then, this shape was used as a ,virtualŠ indentation probe in a 3-dimensional finite-element analysis (FEA) of indentation on <100>-oriented single-crystal tungsten. Simultaneously, experiments were carried out with the real indenter, also on <100>-oriented single-crystal tungsten. There is good agreement between the FEA and experimental load-displacement curves. The Hertzian estimate of the radius of curvature was significantly larger than that directly measured from the scanning-probe experiments. This effect was also replicated in FEA simulation of indentation by a sphere. These results suggest that Hertzian estimates of the maximum shear stresses in the target material at the point of dislocation nucleation are a conservative lower bound. This is not only due to stress concentration by asperities or an aspheric probe, and use of the Hertzian approximation outside of its range of validity.
Citation: Journal of Materials Research
Volume: 80
Issue: 12
Pages: 2 pp.
Keywords: nanoindentation, Hertzian contact, finite element modeling, dislocation nucleation
Research Areas: Metals