Vibration-induced PM and AM noise in microwave components

Published

October 1, 2009

Author(s)

Archita Hati, Craig W. Nelson, David A. Howe

Abstract

The performance of microwave components is sensitive to vibrations to some extent. Among them, microwave cables and connectors, bandpass filters, mechanical phase shifters and some non-linear components are the most sensitive. The local oscillator is one of the prime performance-limiting components in microwave systems ranging from a simple RF receiver to advanced radars. The increasing present and future demand for low acceleration sensitive oscillators, approaching 10^-13/g, requires a re-examination of sensitivities of basic non-oscillatory building block components under vibration. The purpose of this paper is to study the performance of an assortment of oscillatory and non-oscillatory microwave components at 10 GHz under vibration. We point out some challenges and provide few tips for accurate measurement of vibration sensitivity of these components. We also study the affect of vibration on the amplitude modulated (AM) noise.

Citation

IEEE Transactions on Ultrasonics Ferroelectrics and Frequency Control

Volume

56

Issue

10

Pub Type

Journals

Download Paper

Local Download

Keywords

acceleration sensitivity, amplitude modulated noise, phase modulated noise, vibration

Citation

Hati, A. , Nelson, C. and Howe, D. (2009), Vibration-induced PM and AM noise in microwave components, IEEE Transactions on Ultrasonics Ferroelectrics and Frequency Control, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=901491 (Accessed April 24, 2024)