Head and Media Challenges for 3 Tb/in2 Microwave Assisted Magnetic Recording

Published

February 3, 2014

Author(s)

Thomas J. Silva, Justin M. Shaw, Hans T. Nembach, Mike Mallary, Kumar Srinivasan, Gerado Bertero, Dan Wolf, Christian Kaiser, Michael Chaplin, Mahendra Pakala, Leng Qunwen, Yiming Wang, Carl Elliot, Lui Francis

Abstract

A specific design for Microwave Assisted Magnetic Recording (MAMR) at about 3Tb/in² (0.47 Tb/cm² or 4.7 Pb/m²) is discussed in detail to highlight the challenges of MAMR and to contrast its requirements with conventional Perpendicular Magnetic Recording (PMR). In particular it has been determined that MAMR-optimized media should have: higher damping than today’s PMR media upon which Ferromagnetic Resonance (FMR) measurements are reported, very low intergranular exchange coupling, and somewhat stronger layer to layer exchange coupling. It was found that with exchange coupled composite type media (i.e. graded anisotropy with controlled exchange), a Spin Torque Oscillator (STO) in the write gap of a wider shielded pole cannot adequately define the written track at high track density. Adequate lateral field gradient, however, is achieved by modifying the pole tip geometry. Other details of this conceptual design are also discussed.

Citation

IEEE Transactions on Magnetics

Pub Type

Journals

Keywords

microwave assisted magnetic recording, spin torque oscillator, field generating layer, damping, ferromagnetic resonance

Citation

Silva, T. , Shaw, J. , Nembach, H. , Mallary, M. , Srinivasan, K. , Bertero, G. , Wolf, D. , Kaiser, C. , Chaplin, M. , Pakala, M. , Qunwen, L. , Wang, Y. , Elliot, C. and Francis, L. (2014), Head and Media Challenges for 3 Tb/in² Microwave Assisted Magnetic Recording, IEEE Transactions on Magnetics (Accessed April 19, 2024)