Test v6LC.2.3.10 - Neighbor Cache Updated, No Neighbor Cache Entry (Hosts Only)
Part A: No TLLA Option, No Redirected Packet Option, Link-layer Address Unchanged
Verify that a host properly updates its Neighbor Cache entry upon receipt of a valid ICMP
Redirect Message.
* [ND] Sections 8.3
* Packet generator
* Monitor to capture packets
Common Setup 1.1 is performed at the beginning of each test part. Wait at least 3
seconds (MAX_MULTICAST_SOLICIT * RETRANS_TIMER) after any previous cleanup to make sure
all previous NCE's are in state No NCE. The Common Test Cleanup Procedure is performed after each
part. The following table details the Redirect message transmitted in each Part:
| TLLA Option |
Redirected Packet Option |
New NC State |
Link-layer Address |
Part |
| No |
No |
No NCE |
Unchanged |
A |
Part A: No TLLA Option, No Redirected Packet Option, Link-layer Address Unchanged
1. TR1 forwards an Echo Request to the HUT. The Source Address is the off-link global address of
TN1. The Destination Address is the global address of the HUT.
2. Observe the packets transmitted by the HUT.
3. TR1 transmits a Redirect message to the HUT. The ICMPv6 Destination Address is the global
address of TN2. The Target Address is the link-local address of TR2. The Redirect message
contains a Target Link-layer Address option or Redirected Packet option according to the table
above.
4. Wait (RETRANS_TIMER * MAX_*CAST_SOLICIT). (3 seconds)
5. TR2 transmits a link-local Echo Request to the HUT.
6. Wait 2 seconds and observe the packets transmitted by the HUT.
Part A
Step 2:
The HUT should respond to the Echo Request using TR1 as a first hop.
Step 6:
The HUT should wait to send a multicast Neighbor Solicitation for TR2 until it
receives the Echo Request in Step 3, indicating the HUT had no NCE for TR2 before Step 3.
* None.