Test v6LC.2.2.23 - Processing Router Advertisment with Route Information Option (Hosts Only)
Part F - PRF change in Route Information Option
Verify that the HUT uses a Route Information Options to choose the next-hop.
* [RFC-4191] - Section 3.1
* Packet generator
* Monitor to capture packets
No Common Test Setup is performed. The Common Test Cleanup procedure is
performed after each part.
Router Advertisement C
IPv6 Header
Next Header: 58
Source Address: TR1's Link Local Address
Destination Address:Multicast Address
|
Router Advertisement
Router Preference: [See Below]
|
|
Source Link-layer Address Option
|
|
Route Information Option
Prefix Length: [See Below]
PRF: [See Below]
Route Lifetime: [See Below]
Prefix: 3ffe:501:ffff:102::
|
|
Router Advertisement B
IPv6 Header
Next Header: 58
Source Address: TR2's Link Local Address
Destination Address:Multicast Address
|
Router Advertisement
Router Preference: [See Below]
|
|
Source Link-layer Address Option
|
|
Route Information Option
Prefix Length: [See Below]
PRF: [See Below]
Route Lifetime: [See Below]
Prefix: 3ffe:501:ffff:102::
|
|
Packet A
IPv6 Header
Next Header: 58
Source Address: TN2's Global Address
Destination Address: HUT's Global Address
|
|
ICMPv6 Echo Request
|
Part F
16. TR1 advertises Router Advertisement C with Route Information Option with the following information:
Length: 2
Prefix Length: 64
PRF: Low
Lifetime: 30 seconds
Prefix:3ffe:501:ffff:102::
17. TR2 advertises Router Advertisement B with Route Information Option with the following information:
Length: 2
Prefix Length: 64
PRF: medium
Lifetime: 30 seconds
Prefix:3ffe:501:ffff:102::
18. TR1 forwards an Echo Request from TN2 with a source address of 3ffe:501:ffff:102::2 to the NUT.
19. TR1 advertises Router Advertisement C with Route Information Option with the following information:
Length: 2
Prefix Length: 64
PRF: High
Lifetime: 30 seconds
Prefix:3ffe:501:ffff:102::
20. TR1 forwards an Echo Request from TN2 with a source address of 2001:2:0:2000::2 to the NUT.
Steps 18:
The NUT should respond to the Echo Request with an Echo Reply with a next-hop of TR2.
Steps 20:
The NUT should respond to the Echo Request with an Echo Reply with a next-hop of TR1.
* None.