Test v6LC.2.1.17 - Neighbor Advertisement Processing, NCE State INCOMPLETE Part E: Receiving NA without Target Link-Layer Address Option
Verify that a node properly updates its Neighbor Cache from the INCOMPLETE state upon receipt of a Neighbor Advertisement.
* [ND] Section 7.2.5
Solicited flag Override flag New State Update Link-Layer Address set set REACHABLE yes set clear REACHABLE yes clear set STALE yes clear clear STALE yes
* Packet generator * Monitor to capture packets
No Common Test Setup is performed. Wait at least 3 seconds (MAX_MULTICAST_SOLICIT * RETRANS_TIMER) after any previous cleanup to make sure all previous NCE's are in state No NCE. The Common Test Cleanup procedure is performed after each part.
Packet A IPv6 Header
Next Header: 58
Source Address: TN1's local Address
Destination Address: NUT's Link-local AddressICMPv6 Echo Request
Neighbor Adv. B IPv6 Header
Next Header: 58Neighbor Adv.
Solicited flag: 1
Override flag: 1
Neighbor Adv. C IPv6 Header
Next Header: 58Neighbor Adv.
Solicited flag: 1
Override flag: 0
Neighbor Adv. D IPv6 Header
Next Header: 58Neighbor Adv.
Solicited flag: 0
Override flag: 1
Neighbor Adv. E IPv6 Header
Next Header: 58Neighbor Adv.
Solicited flag: 0
Override flag: 0
Part E: Receiving NA without Target Link-Layer Address Option 21. TN1 transmits Packet A. 22. Observe the packets transmitted by the NUT. 23. TN1 transmits a Neighbor Advertisement without any Target Link-Layer Address Option. 24. Observe the packets transmitted by the NUT and the NCE of TN1 on the NUT.
Part E
Step 22: After receiving the Echo Request from TN1, the NUT should create a Neighbor Cache Entry for TN1 and set the state of the Entry to INCOMPLETE. The NUT should send a multicast Neighbor Solicitation to TN1.
Step 24: The NUT should ignore the NA transmitted by TN1. There should be no change in the neighbor cache for TN1 as it should stay in state INCOMPLETE. The NUT should continue to send multicast Neighbor Solicitation to TN1.
* None.