NAME

  Test v6LC.2.2.10 - Router Solicitation Processing, Neighbor Cache (Routers Only)
  Part G: RS with SLLA unchanged, NCE STALE

Purpose

   Verify that a router properly updates its Neighbor Cache upon receipt of a Router Solicitation.

References

  * [ND]  Sections 6.2.6 and 7.3.3

Resource Requirements

  * Packet generator
  * Monitor to capture packets

Test Setup

  No Common Test Setup is performed. Wait at least 3 seconds
  (MAX_MULTICAST_SOLICIT * RETRANS_TIMER) after any previous cleanup to make sure all
  previous NCE's are in state No NCE. The Common Test Cleanup procedure is performed after each
  part.

Router Solicitation A
IPv6 Header
Next Header: 58
Source Address: TN1's Link-local Address
Destination Address: All Router multicast address

Router Advertisement
Source Link-layer Option

Echo Request B
IPv6 Header
Next Header: 58
Source Address: TN1's link Address
Destination Address: HUT's Global Address

ICMPv6 Echo Request

Neighbor Advertisement C
IPv6 Header
Next Header: 58
Source Address: TR1's Link-local Address
Destination Address: RUT's Link-local Address

Neighbor Advertisement
Router flag: 0
Solicited flag: 1
Override flag: 1

Router Solicitation A
IPv6 Header Next Header: 58 Source Address: TN1's Link-local Address Destination Address: All Router multicast address
Router Advertisement Source Link-layer Option

Echo Request B
IPv6 Header Next Header: 58 Source Address: TN1's link Address Destination Address: HUT's Global Address
ICMPv6 Echo Request

Neighbor Advertisement C
IPv6 Header Next Header: 58 Source Address: TR1's Link-local Address Destination Address: RUT's Link-local Address
Neighbor Advertisement Router flag: 0 Solicited flag: 1 Override flag: 1

Procedure

  Part G: RS with SLLA unchanged, NCE STALE
   28. Repeat Steps 20 through 26, transmitting Router Solicitation A in Step 25 with the same Source
       Link-layer Address.
   29. Check the NCE of TR1 on the RUT and observe the packets transmitted by the RUT.

Observable Results

  Part G
   Step 21:
   The RUT should create a Neighbor Cache Entry for TN1 and set the state of the
   Entry to INCOMPLETE. The RUT should send a multicast Neighbor Solicitation to TN1.

   Step 23:
   The RUT should update the state of TN1's NCE to REACHABLE and record
   TN1's Link-layer Address. Because the RUT is in state REACHABLE, after receiving the
   earlier Echo Request from TN1, the RUT should send an Echo Reply using the received
   Link-Layer Address. After DELAY_FIRST_PROBE_TIME, the RUT should not send a
   unicast Neighbor Solicitation to TN1.

   Step 29:
   The RUT should remain in state STALE, send an Echo Reply to TN1 using the
   unchanged Link-Layer address and enter state DELAY. After
   DELAY_FIRST_PROBE_TIME, the RUT should send a unicast Neighbor Solicitation to

Possible Problems

  * None.