Test v6LC.2.2.6 - Router Does Not Send Router Advertisements on Non-advertising Interface (Routers Only)
Part B: Advertising interface
Verify that a router does not send Router Advertisements on non-advertising interfaces.
* [ND] Section 6.2.2
* Packet generator
* Monitor to capture packets
Enable Interface A on Link B and Interface B on Link A. No Common Test Setup is
performed. The Common Test Cleanup procedure is performed after each part.
Router Solicitation A
IPv6 Header
Next Header: 58
Source Address: :: (Unspecified)
Destination Address: FF02::2
|
| Router Solicitation |
|
Router Solicitation B
IPv6 Header
Next Header: 58
Source Address: TN1 link-local
Destination Address: FF02::2
|
| Router Solicitation |
|
Router Solicitation C
IPv6 Header
Next Header: 58
Source Address: TN2 link-local
Destination Address: FF02::2
|
| Router Solicitation |
|
|
Part B: Advertising interface
4. If the RUT supports two physical network interfaces. Configure Interface A on the RUT to be an
advertising interface and Interface B to be a non-advertising interface.
5. Configure TN1 to transmit Router Solicitation A to the RUT on Interface A.
6. Observe the packets transmitted by the RUT on Interface A.
7. Configure TN1 to transmit a Router Solicitation B to the RUT on Interface A.
8. Observe the packets transmitted by the RUT on Interface A.
9. Configure TN2 to transmit Router Solicitation A to the RUT on Interface B.
10. Observe the packets transmitted by the RUT on Interface B.
11. Configure TN2 to transmit Router Solicitation C to the RUT on Interface B.
12. Observe the packets transmitted by the RUT on Interface B.
Part B
Step 6: The RUT must send Router Advertisements out on Interface A.
Step 8: The RUT must send Router Advertisements out on Interface A.
Step 10: The RUT must not send Router Advertisements out on Interface B.
Step 12: The RUT must not send Router Advertisements out on Interface B.
* Part B may be omitted if the Router does not support two physical interfaces.