NIST logo

Publications Portal

You searched on:
Author: beverly payne
Sorted by: title

Displaying records 1 to 10 of 15 records.
Resort by: Date / Title


1. A Next Generation Electrodynamic Shaker for the Primary Calibration of Accelerometers
Series: NIST Interagency/Internal Report (NISTIR)
Report Number: 7724
Published: 9/1/2010
Authors: Beverly Francis Payne, Kari K Harper
Abstract: A shaker system was designed to allow direct primary calibration of accelerometers using both reciprocity and interferometer techniques over the frequency range 40 Hz to 10,000 Hz. The system use dual magnets and a dual-coil moving element. The desig ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=906791

2. Accelerometer Calibration at NBS/NIST, The Last Thirty Years.
Published: 11/22/1997
Author: Beverly Francis Payne
Abstract: This paper gives a short history of the development of the accelerometer calibration services at NBS/NIST from the mid-1950s to 1996. Many people were involved in the research and development that has led to the present calibration services. The refe ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=820002

3. Comparison of Results of Calibrating the Magnitude of the Sensitivity of Accelerometers by Laser Interferometry and Reciprocity
Published: 1/1/1999
Authors: Beverly Francis Payne, David J Evans
Abstract: Minimizing the uncertainty in the calibration of accelerometers by the reciprocity method requires minimizing the cross-axis component of the induced motion, and the distortion of its waveform. Minimizing the uncertainty in the calibration of acceler ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=823263

4. Errors in Accelerometer Calibration Using Laser interferometry Due to Harmonic Distortion and Cross Motion in the Applied Motion
Published: 6/1/2000
Authors: Beverly Francis Payne, David J Evans
Abstract: The development of exciters for the precise calibration of accelerometers requires minimizing distortion and cross motion in the exciter (shaker). It is well known that both distortion and cross motion can introduce significant errors in the calibrat ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=821918

5. Improvements in Accelerometer Calibration Using Fringe Counting and Minimum Point Methods
Published: 10/1/2003
Authors: Beverly Francis Payne, Kari K Harper
Abstract: Improvements in shaker and interferometer design at NIST have provided more reliable calibration of accelerometers by laser interferometry. A dual-coil shaker provides excitation with low distortion and low cross-axis motion. Calibrations are pe ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=822102

6. International Comparison of Acceleration Standards - Preliminary Results of SIM Project AV-1
Published: 11/1/1999
Authors: G R Ripper, Beverly Francis Payne, G Silva Pineda
Abstract: This paper presents the preliminary results obtained in an international intercomparison of the calibration of acceleration standards by participating laboratories of the Inter-American Metrology System (SIM). Participating laboratories were the Nati ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=823274

7. International comparison of acceleration standards - Preliminary results of the SIM project AV-1
Published: 1/1/1999
Authors: G R Ripper, Beverly Francis Payne
Abstract: This paper presents the preliminary results obtained in an international comparison on the calibration of acceleration standards by participating laboratories of the Interamerican Metrology System (SIM). Participating laboratories were the National M ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=820096

8. Laser Interferometer and Reciprocity Calibration of Accelerometers Using the NIST Super Shaker
Published: 11/1/1998
Author: Beverly Francis Payne
Abstract: The development of the NIST Super Shaker permits calibration of accelerometers by two independent and absolute methods on the same shaker. Minimizing the uncertainty of reciprocity calibrations imposes stringent requirements for distortion and cross- ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=820066

9. Modeling and Experimental Analysis of Piezoelectric Shakers for High-Frequency Calibration of Accelerometers
Published: 6/22/2010
Authors: Gregory W Vogl, Kari K Harper, Beverly Francis Payne
Abstract: Piezoelectric shakers have been developed and used at NIST for decades for high-frequency calibration of accelerometers. Recently, NIST researchers built new piezoelectric shakers in the hopes of enabling more accurate calibrations of accelerometers ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=905341

10. Piezoelectric Shaker Development for High Frequency Calibration of Accelerometers
Published: 6/22/2010
Authors: Beverly Francis Payne, Gregory W Vogl, Kari K Harper
Abstract: Calibration of vibration transducers requires sinusoidal motion over a wide frequency range with low distortion and low cross-axial motion. Piezoelectric shakers are well suited to generate such motion and are suitable for use with laser interferomet ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=905194



Search NIST-wide:


(Search abstract and keywords)


Last Name:
First Name:







Special Publications:

Looking for a NIST Special Publication (NIST SP Series)? Place the series number and dash in the report number field (Example: 800-) and begin your search.

  • SP 250-XX: Calibration Services
  • SP 260-XX: Standard Reference Materials
  • SP 300-XX: Precision Measurement and Calibration
  • SP 400-XX: Semiconductor Measurement Technology
  • SP 480-XX: Law Enforcement Technology
  • SP 500-XX: Computer Systems Technology
  • SP 700-XX: Industrial Measurement Series
  • SP 800-XX: Computer Security Series
  • SP 823-XX: Integrated Services Digital Network Series