NIST logo

Publications Portal

You searched on:
Author: douglas olson

Displaying records 11 to 20 of 26 records.
Resort by: Date / Title


11. NIST Special Publication 250-39 2009 NIST Calibration Services for Pressure Using Piston Gauge Standards
Series: Special Publication (NIST SP)
Published: 7/1/2009
Author: Douglas A Olson
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=902889

12. Effect of Dissolved Nitrogen Gas on the Density of Di-2-Ethylhexyl Sebacate: Working Fluid of the NIST Oil Ultrasonic Interferometer Manometer Pressure Standard
Published: 6/1/2009
Authors: Jay H Hendricks, Jacob R Ricker, Justin H Chow, Douglas A Olson
Abstract: The National Institute of Standards and Technology (NIST) Low Pressure Manometry Laboratory maintains national pressure standards ranging from 1 mPa to 360 kPa through the operation of four ultrasonic interferometer manometer (UIM) pressure standards ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=900223

13. Bilateral Comparison Between NIST (USA) and NPLI (India) in the Pneumatic Pressure Region 0.4 MPa to 4.0 Mpa
Published: 3/5/2007
Authors: Robert G Driver, Douglas A Olson, Nita Dilawar, A Bandyopadhyay
Abstract: We report the results of a bilateral comparison of pressure measurement between NIST and NPLI using a piston gauge transfer standard (TS), designated as NPLI-4, over the range of nominal applied pressure 0.4 MPa to 4.0 MPa. This TS was cross-floated ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=830946

14. Bilateral Comparison between NIST (USA) and NPLI (India) in the Hydraulic Pressure Region 40 MPa to 200 Mpa
Published: 8/1/2006
Authors: Robert G Driver, Douglas A Olson, S Yadav, A Bandyopadhyay
Abstract: We report here the results of a bilateral comparison of pressure measurement between the National Institute of Standards and Technology (NIST), Gaithersburg, USA and the National Physical Laboratory (NPLI), New Delhi, India, over the range of nominal ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=830901

15. Primary Pressure Standards Based on Dimensionally Characterized Piston/Cylinder Assemblies
Published: 2/1/2006
Authors: James W Schmidt, K. Jain, A P. Miiller, Walter J. Bowers Jr., Douglas A Olson
Abstract: NIST has characterized two large diameter (35.8 mm) piston/cylinder assemblies as primary pressure standards in the range from 0.05 to 1.0 MPa with uncertainties approaching the best mercury manometers. The realizations of the artifacts as primary st ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=830935

16. Characterization of a compact 200 MPa controlled clearance piston gauge as a primary pressure standard using the Heydemann and Welch method
Published: 1/1/2006
Authors: Ashish K. Bandyopadhyay, Douglas A Olson
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=901908

17. Accurate Determination of Equilibrium State Between Two Pressure Balances Using a Pressure Transducer
Published: 7/1/2005
Authors: T Kobata, Douglas A Olson
Abstract: To determine an equilibrium state between two pressure balances accurately, the measurement method using a precise pressure transducer and two air-operated constant volume valves is proposed in this paper. The advantages of the proposed methods are a ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=830944

18. Automating the Calibration of Two Piston Gage Pressure Balances
Published: 8/1/2002
Authors: Douglas A Olson, T Kobata
Abstract: We propose a method to automate the data-gathering process in the cross-float calibration of one piston gage pressure balance against a second piston gage pressure balance. Rather than adjusting small trim masses until the balances generate equal pr ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=830781

19. Characterization of a Controlled-Clearance Piston Gauge Using the Heydemann-Welch Model
Published: 8/1/2002
Authors: T Kobata, James W Schmidt, Douglas A Olson
Abstract: A study on the characterization of a controlled-clearance piston gauge was performed at the National Institute of Standards and Technology (NIST). The characterization covers the pressure range from 37.5 MPa to 288 MPa, at jacket pressures up to 76 ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=830784

20. Capabilities and Uncertainties of the Piston Gage Pressure Standards at NIST
Published: 11/30/2001
Author: Douglas A Olson
Abstract: The National Institute of Standards and Technology operates and maintains piston gage pressure standards from 7 kPa to 280 Mpa, a span of over 4 decades in pressure. Gas capabilities range from 7 kPa to 1000 Mpa, and oil capabilities range from 1 ...
http://www.nist.gov/manuscript-publication-search.cfm?pub_id=830327



Search NIST-wide:


(Search abstract and keywords)


Last Name:
First Name:







Special Publications:

Looking for a NIST Special Publication (NIST SP Series)? Place the series number and dash in the report number field (Example: 800-) and begin your search.

  • SP 250-XX: Calibration Services
  • SP 260-XX: Standard Reference Materials
  • SP 300-XX: Precision Measurement and Calibration
  • SP 400-XX: Semiconductor Measurement Technology
  • SP 480-XX: Law Enforcement Technology
  • SP 500-XX: Computer Systems Technology
  • SP 700-XX: Industrial Measurement Series
  • SP 800-XX: Computer Security Series
  • SP 823-XX: Integrated Services Digital Network Series