NIST logo
*
Bookmark and Share

Measurements for Hydrogen Storage Materials

Summary:

The goal of this project is to develop the metrology necessary for rapid, high-throughput measurement of the hydrogen content of novel materials proposed for hydrogen storage. A focus is bringing Prompt Gamma Activation Analysis, a direct method requiring a neutron source and thus not commonly available, to the stage where it can be used as a reference method for the calibration of indirect methods that are more readily available to the research community, such as infrared spectroscopy (IR).

Description:

The evaluation of candidate storage materials is complicated by a lack of readily available methods for the direct measurement of hydrogen content. MML is working together with researchers from NCNR, and PML to provide measurement tools to fill this gap. Prompt Gamma Activation Analysis (PGAA) is a direct method for measuring hydrogen, but is not commonly accessible since it requires a neutron source. Infrared (IR) and Raman imaging/spectroscopy methods, being developed at NIST, could be made widely available, but are not capable of directly measuring hydrogen content. Using measurements of hydrogen content with PGAA to calibrate IR and Raman imaging/ spectroscopy methods, NIST will provide accurate combinatorial screening methods widely usable by industry with the high spatial resolution needed for the development of storage materials. These methods are being tested on compositionally graded thin films that the Materials Science and Engineering Division prepares using a multilayer-deposition technique in a customized e-beam deposition chamber. Currently the focus is on Mg-based films, which are of great interest to the hydrogen storage scientific community.

Additional Technical Details:

As the first step towards correlating IR results with those obtained using PGAA, the Materials Science and Engineering Division has successfully demonstrated that in-situ IR emissivity imaging method is able to capture the reaction between Mg-TM (TM - transition metal) thin films and hydrogen gas. The method has been shown to be sensitive to variations in composition and microstructure.

hydrogen storage materials PGAA spectra
PGAA spectra example


Thin films of MgxNi1-x and MgxTi1-x with a composition gradient corresponding to 0.95>x>0.4 were capped with Pd to prevent oxidization of the films and to catalyze the hydrogenation reaction. The composition of the films was selected for two reasons: (1) high gravimetric density of hydrogen in MgH2 and the need for better knowledge of the thermodynamics and kinetics of the process; (2) the desire for two-phase microstructures in the material, with one phase responsible for hydrogen storage and the other for fast hydrogen delivery.
Hydrogen absorption/desorption of the films was studied by acquiring IR images in-situ using the chamber pictured below.

Hydrogenation chamber with IR optics
Hydrogenation Chamber with IR optics

The compositionally graded films are clamped to a heating stage inside the hydrogenation chamber and IR emission images are continuously collected through a sapphire window. The IR camera used permits “snap-shot” imaging (with 10 microsecond or longer integration times). The camera has its peak sensitivity at a wavelength of 5 micrometers, but it is able to detect over an integrated range of 1.0 to 5.5 microns.

The IR emission images are analyzed post acquisition by means of an image analysis software to extract the temporal intensity evolution for each pixel, corresponding to a given value of the composition gradient. Normalized IR intensities (with respect to a fixed region in the Si substrate) are then plotted as a function of measurement time (therefore, as function of hydrogenation conditions) along the composition gradient.

Normalized IR intensity of MgxNi1-x
Normalized IR intensity of MgxNi1-x.

Evolution of the normalized IR intensities during hydrogenation experiments are shown to the right for MgxNi1-x and MgxTi1-x films. In these experiments the films were initially equilibrated at 150 ˚C prior to exposing the samples to hydrogen, thus the change in the film’s IR emissivity during hydrogenation could be attributed only to the changes in the amount of hydrogen in a film. The curves were offset to show the evolution of IR intensity with time for the given compositions across the gradient. The conditions of the hydrogenation experiments: hydrogen pressure PH (bar) and film’s temperature TS (˚C) are depicted with each figure.

Normalized IR intensity of MgxTi1-x
Normalized IR intensity of MgxTi1-x

Major Accomplishments:

  • Hydrogen is promoted as petroleum replacement in the Hydrogen Economy. It presents an attractive potential for fueling automobiles and trucks while maintaining a healthier global environment. A major roadblock associated with the use of hydrogen is the inability to store it efficiently.
  • Enabling high throughput measurement tools for determining hydrogen absorption/desorption characteristics will accelerate discovery of new materials which can store hydrogen in a useful manner.
  • Correlating direct and indirect measurements of the hydrogenation process and applying the methods developed to measure combinatorial samples is essential in developing the high throughput methodology.
  • Industrial R&D, academia, and national labs are potential customers to use the developed methods as a fast screening tool in their research of novel materials for hydrogen storage.
hydrogen storage materials schematic

End Date:

ongoing

Lead Organizational Unit:

mml

Staff:

Gregory Downing
Liz Mackey
Raymond Cao
Hiroyuki Oguchi
Ted Heilweil (PML)

Leonid Bendersky (MSED)
(301) 975-6167
leonid.bendersky@nist.gov

Associated Products:

Contact

General Information:
Leonid Bendersky

301-975-6167 Telephone
301-975-4553 Facsimile

100 Bureau Drive, M/S 8555
Gaithersburg, MD 20899-8555