NIST logo

Publication Citation: Oxidation of Deuterium-, Acetylene-, and Ethylene-Terminated Si(100) by Atomic Oxygen

NIST Authors in Bold

Author(s): Maritoni A. Litorja; Steven A. Buntin;
Title: Oxidation of Deuterium-, Acetylene-, and Ethylene-Terminated Si(100) by Atomic Oxygen
Published: January 01, 2002
Abstract: The oxidation of deuterium-, ethylene- and acetylene-terminated Si(100) by gas-phase atomic oxygen is evaluated using Auger electron spectroscopy. The atomic oxygen is generated by the 157 nm laser photolysis of O2, which results in nominally a 50/50 mix of the ground (3P) and electronically-excited (1D) state species. O atom adsorption probabilities for oxygen coverages in the 1 to 3 monolayer (ML) regime are estimated to be on the order of 0.1 for these adlayer systems. For both C2H4 and C2H2 adlayers no effective loss of surface carbon is observed, indicating that there first must be extensive oxidation of the near-surface region (greater than about 3 ML) prior to the removal of chemisorbed carbon on Si(100). The O atom oxidation for oxygen coverages of about 1 ML to 3 ML in the near-surface regime is found to be linear with O atom exposure for all three adlayers, with the propensity for reaction being given by the relative slopes of 2.0:1.4:1.0 for C2H4-, C2H2- and D-terminated Si(100), respectively. The relatively low rate for O atom oxidation of D-terminated Si(100) suggests that the presence of defects facilitates the oxidation. While the difference in the oxidation rates for the C2H4 and C2H2 adlayers is statistically significant, this is most likely not due to initial adlayer coverage effects; the specific cause(s) of this difference, however, is not established.
Citation: Journal of Vacuum Science and Technology A
Volume: 20
Issue: No. 1
Keywords: acetylene;adsorption;atomic oxygen;electronic excitation;ethylene;Si(100);silicon oxidation;surface carbon
Research Areas: