Influence of Impedance Mismatch Effects on Measurements of Unloaded Q Factors of Transmission Mode Dielectric Resonators

Published

June 1, 2003

Author(s)

Kenneth Leong, James Booth, Sang Y. Lee

Abstract

Precise measurements of the surface resistance of high temperature superconducting thin films using transmission mode dielectric resonators requires accurate knowledge of the unloaded Q factor. So far, the most accurate method of unloaded Q factor determination for transmission mode resonators is the Transmission Mode Q Factor (TMQF) technique based on the processing of input S-parameters (S₂₁,S₁₁,S₂₂). The technique accounts for parasitic effects including noise, crosstalk, coupling reactance and coupling losses but does not yet take into account impedance mismatch between the test ports of the vector network analyzer and the inputs to the resonator. Discrepancies between measured and ideal S-parameters due to the mismatch lead to inaccuracies in coupling coefficient computations. This causes undesirable error in the calculated unloaded Q factor. In this paper, we present measurements of unloaded Q factors obtained using the TMQF technique for mismatched and matched connections between the test ports of the vector network analyzer and the inputs to the dielectric resonator. These results are compared with values obtained using the traditional Insertion Loss method.

Citation

IEEE Transactions on Applied Superconductivity

Volume

13

Issue

2

Pub Type

Journals

Keywords

dielectric resonators, HTS films, microwave measurements, Q factor, surface resistance

Citation

Leong, K. , Booth, J. and Lee, S. (2003), Influence of Impedance Mismatch Effects on Measurements of Unloaded Q Factors of Transmission Mode Dielectric Resonators, IEEE Transactions on Applied Superconductivity (Accessed April 25, 2024)